(See Figure #5)Ħ. Secure the lower mounting points loosely using the provided (2) M8-1.25圆5 Hex Bolts, (2) ¼” Flat Washers, and (2) 1-1/8” Aluminum Spacers. (See Figure #4)ĥ. Lift the winch mount plate to meet the mounting points on the front bumper and loosely secure the two parts with the provided (2) M8-1.25x20 Hex Bolts, (4) ¼” Flat Washers, and (2) M8-1.25 Nylock Nuts. If there is excess movement in the spacer with the hardware installed add (1) of the provided ¼” Flat Washers to each side to prevent the spacer from rattling when riding. Note: If installing a winch at this time it is recommended to install the winch on the mounting place prior to installing the plate on the vehicle.Ĥ. Bring the front bumper up to the vehicle and begin mounting it to the front cargo rack using the original hardware saved from the original bumper and the provided (2) 33mm Aluminum Spacers. (See Figure #2)ģ. Install the Winch Mount Plate with mounting tabs facing down using the provided (2) M8-1.25x20 Hex Bolts, and (2) ¼” Flat Washers. Trim off the area below the yellow line depicted. (See Figure #1)Ģ. Trim the plastic front fascia as shown in the image below on both sides. Save the nuts and bolts securing the original bumper to the front cargo rack, they will be used later during installation. Also remove the two smaller bolts securing the front fascia plastics to the bumper. 1. Remove the original front bumper from the original (6) mounting points at the front cargo rack, below the radiator, and at the bottom of the frame.

2018 honda rancher 420 plastics